Custom Stamped Parts
-
![Sheet Metal Part]()
Sheet Metal PartA stamped sheet metal part can range from a flat bracket to a drawn cover, and the manufacturing route should be chosen from the drawing rather than from the product name alone. Material grade,...read more -
![Sheet Metal Stamping Part]()
Sheet Metal Stamping PartThis Sheet Metal Stamping Part is a 5.0 mm S275JR bumper reinforcement bracket. The gauge is substantially heavier than ordinary light-sheet work, so blanking force, press energy, die stiffness,...read more -
![Pressed Component]()
Pressed ComponentA sheet metal pressed component in 1.15 mm P260D+Z can be developed for an automotive deep-drawn application where material flow and coating protection must be balanced. The forming route should...read more -
![Pressed Part]()
Pressed PartA precision pressed part in 3.2 mm JAH440 is intended for an automotive seat application where structural stiffness and repeatable mounting geometry are important. The combination of material...read more -
![Stamping Product]()
Stamping ProductThis metal stamping product is a 0.4 mm aluminum lamp cover. Its low weight is useful, but the thin sheet can dent, wrinkle, or show tool marks with very little mishandling. Tooling and part...read more -
![Stamped Component]()
Stamped ComponentA precision stamped component in 3.0 mm S355MC is suited to an automotive seat structure where strength, hole alignment, and repeatable flange geometry are required. The material and gauge call...read more -
![Stamping Component]()
Stamping ComponentA precision stamping component in 1.0 mm SUS439MT can serve as an exhaust-pipe heat shield where profile, mounting position, and edge condition are more important than a heavy structural load. The...read more -
![Metal Stamped Part]()
Metal Stamped PartThis Metal Stamped Part is a 2.5 mm CR4 mounting bracket for an engine cylinder-block heater. The bracket must hold its mounting geometry after forming and still provide enough stiffness around...read more -
![Stamping Part]()
Stamping PartA precision stamping part made from 0.35 mm silicon steel must hold electrical geometry as carefully as mechanical dimensions. For motor stator or rotor laminations, burr height, slot profile,...read more
With abundant experience, we are one of the most reliable custom stamped parts manufacturers and suppliers in China. Please feel free to buy advanced custom stamped parts made in China here from our factory. Good service and quality products are available.